In reply to Ian Bakshan’s post on February 24, In reply to Ratandeep’s post on February 22, Check if at all there is an exclamation mark along the driver, it suggests issues with the driver installed. I would suggest you to try following methods and check if it helps. Shows up in Device Manager: I will contact Atmel Tech support but in the interim, I was able to successfully get this hardware working on my laptop this morning.
|Date Added:||8 March 2006|
|File Size:||43.59 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Ratandeep and Ian, I will contact Atmel Tech support but in the interim, I was able to successfully get this hardware working on my laptop this morning. Now launch a command prompt with elevated privileges Right click cmd.
Thanks for your feedback, it helps us improve the site. Hello, There is no known issue junbo WinDriver that requires uninstalling and then re-installing it.
No Tool is recognized by Atmel Studio, but the Driver seems to be Working
You can follow the question or vote as helpful, but you cannot reply to this thread. Hello Dean, Jungp you for keeping us updated on the status of the issue.
Ratandeep Replied on February 24, So I started to dig this out and see if I can fix things myself and I am pretty much pleased that I was able to make it work. Sorry, your blog cannot share posts by email.
Click Start, and then click Control Panel. Ian Bakshan Replied on February 24, This site in other languages x. I appreciate your efforts.
Disconnect all USB devices and then perform the following steps: So here is the story of it. Please run these Microsoft Fixit and jungoo the issue.
Jungo Connectivity Driver
Though there are a lot of beautiful that can happen for a typical Friday night, but am in middle of a STKa Dell Latitude with Windows 7 X64 and a broken connection between these two.
By continuing to use this website, you agree to their use. Can anyone tell me how I can purge all the remnants of these drivers so that I jingo attempt a successful re-install?
Setting up the AVR Jungo USB Driver manually | Atmel studio
Repeat the step 2 to uninstall all items under “Universal Serial Bus controllers”. Is the issue specific to this device?
Now some logs will appear and it should say succeeded. In reply to Ratandeep’s post on February 22, After that go to the folder c: Tech support scams are an industry-wide issue where scammers attempt to trick you into paying for unnecessary technical support services.
My STK was not detected either by Studio 5. Firmware version 3 and later uses a HID interface for communication. I have the same question In reply to DeanP’s post on February 25, Thanks for taking the time to read through my question.